Add to Cart:

Diamond Drag Engraving Bit 90 degree 1/8x5

 
 
 
1/8 diameter 5 inches length 90degree diamond bit for all engraving machines with a 1/8 collet.
Drag Engravers - Diamond tipped engraving tools. (Non-rotating drag engraver)
The standard Drag Engraver is ground to a 90 degree point and then lapped to a polish at the tip to provide a smooth finish.
This is a perfect bit for very fine narrow engraving and deeper engravings in Stainless steel.
Additional angles are 120 degree which is a general use bit producing a wider engraving but not as deep as the 90 degree.
I only offer Made in USA engraving bits.
 Time proven and the best in the market. 
I have engraved with this brand for 5 years and stand by the bits 100%
There are Cheaper China made bits but trust me they are NO where near the quality of these American made diamonds.

$24.99 each